Basic BIOS Tweaking Guide

Basic BIOS Tweaking Guide

When your computer starts up either hold the DEL key or when you see a message saying change setting or something similar to that press DEL. No we are in the bios, you should see a blue screen with a few menu options. These setting were designed for a ABIT Bios but I’m sure you’ll find the below options in newer motherboards. The order of these options may also be different so based on your system you may have to look around for it’s location on your system.

Here goes:

Turbo Frequency – Enabled (only on 66mhz and 100mhz bus)
Multiplier Factor – CPU default
SEL 100/66# Signal – Set LOW
AGPCLK/CPUCLK – Safest setting is 1/1
L2 cache Latency – As low as possible
Speed Error Hold – Enable in case of errors
CPU Power Supply – User Define, anywhere from 2.0v to 2.3 depending on power supply

Virus Warning – Enable
CPU Level 1 Cache – Enable
CPU Level 2 Cache – Enable
CPU L2 Cache ECC Checking – Disable
Quick Power On Self Test – Enable
Boot Sequence – C,A,SCSI is fastest, doesn’t really matter whatever suits you best
Swap Floppy Drive – Disable
Boot Up Floppy Seek – Disable
IDE HDD Block Mode – Enable
PCI/VGA Palette Snoop – Disable, unless video card manual says
Delay for HDD – 0
Video BIOS Shadow – Disable
Shadow address ranges Disable as default

SDRAM CAS Latency Time – 2, if unstable use 3
SDRAM Precharge Control – Enable
DRAM Date Integrity Mode – Non-ECC, if you are using ECC memory enable ECC
System BIOS Cacheable – Disable
Video BIOS Cacheable – Disable
Video RAM Cacheable – Disable
8 Bit I/O Recovery Time – 1
16 Bit I/O Recovery Time – 1
Memory Hole At 15M-16M – Disable
Passive Release – Enable
Delayed Transaction – Enable

It’s just an explanation and/or suggested settings for the BIOS. Nothin more, nothing less